Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Ultegra 6800
#7
I may have rounded up the cable pull somewhat, got a new 3D print ordered with less diameter (20 mm vs 32 mm). May take a few days as it is national holiday week in Shenzhen/China.
Will update results once received.


Messages In This Thread
Ultegra 6800 - by Zaphod - 10-04-2020, 11:26 AM
RE: Ultegra 6800 - by Jan Oelbrandt - 10-04-2020, 03:30 PM
RE: Ultegra 6800 - by Zaphod - 10-04-2020, 05:11 PM
RE: Ultegra 6800 - by visitor007 - 10-05-2020, 11:48 AM
RE: Ultegra 6800 - by Fesh - 01-13-2021, 01:20 PM
RE: Ultegra 6800 - by Jan Oelbrandt - 01-14-2021, 12:58 PM
RE: Ultegra 6800 - by Jan Oelbrandt - 10-04-2020, 05:44 PM
RE: Ultegra 6800 - by Ed_R - 10-05-2020, 01:11 PM
RE: Ultegra 6800 - by Zaphod - 10-05-2020, 01:55 PM
RE: Ultegra 6800 - by Jan Oelbrandt - 10-05-2020, 03:07 PM
RE: Ultegra 6800 - by Ed_R - 10-05-2020, 08:59 PM
RE: Ultegra 6800 - by Zaphod - 10-17-2020, 03:33 AM
RE: Ultegra 6800 - by Jan Oelbrandt - 10-17-2020, 09:51 AM
RE: Ultegra 6800 - by Zaphod - 10-18-2020, 01:15 AM
RE: Ultegra 6800 - by Jan Oelbrandt - 10-18-2020, 07:52 AM
RE: Ultegra 6800 - by Zaphod - 10-18-2020, 01:25 PM
RE: Ultegra 6800 - by Jan Oelbrandt - 10-18-2020, 02:47 PM
RE: Ultegra 6800 - by Zaphod - 10-22-2020, 08:32 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)